I needed a way to mount a Sony 40" Z series LCD in my TV cabinet that used to house a 36" CRT. The problem with using the provided TV stand was that it protruded several inches in front of the panel for balance, which meant the TV had to be pushed back into the cabinet restricting the viewing angle from the sides more than I would like.

So, I found this stand from Premier Mounts, and mounted the panel facing out the "back" of the stand, and then secured the base with some brackets to my TV cabinet - works great as I now have the TV flush with the front of the cabinet (inset just enough for the doors to close) and have full viewing ability.

While another reviewer commented on not having the needed screws, I was impressed with the large variety of mounting screws that were provded in the kit - found some that met my needs for the Sony 40Z4100 fine. There are a couple of horizontal brackets that I am not sure are needed I did have to cut off a portion of one side of the lower mounting arm as it interfered with the input panel on the back of the TV, but this does not reduce the structral strength in any way.

The stand is made of very good quality, heavivy duty materials and if for some reason you have misplaced your original table stand this would make an ideal replacement - or a great option for needs like mine above :)

This tabletop stand is great. Nice, modern appearance and very sturdy with an adjustable height. My husband assembled it in no time. It fit our 32 inch Sony Bravia perfectly!

I ordered the Tabletop stand because my TV didn't come with one and I didn't want to hang my TV on the wall. I wanted a stand that would support the TV and also look nice and not cost me a bundle. I got what I wanted. The stand supports my 42" TV with no problem and also looks great. It was easy and quick to assemble. I would recommend it to anyone looking for a tabletop stand for their tv.

It is a nice piece of fixture but be aware it didnt come with all necessary screws, I had to go to my local hardware stor and uy necessary stuff so if you are looking for a DIY stay away from this one

I am very satisfied with this stand. It is solid, attractive, and easy to assemble. It makes it possible to position the bottom of the display as little as 1.75 inches above the surface on which the stand rests. Note that the horizontal mounting brackets screw into the holes normally used for a wall mount system. Depending on where your input jacks are located, the mounting brackets could make access difficult. Provision for a swivel base would be welcome.